Recently, PCD Peeling Die, a key product in the superhard tool sector, has been widely adopted in welding wire, cable and special metal wire industries. Featuring ultra-high wear resistance, high precision and long service life, it gradually replaces traditional carbide peeling dies. It serves as core tooling to remove oxide scale, scratches and impurity layers from the wire surface in the pre-process stage. It supports stable mass production on metal wire production lines and cuts downtime costs caused by die replacement.
PCD Peeling Die is composed of a polycrystalline diamond core combined with a carbide substrate. With precisely formed cutting edges, it evenly scrapes off oxide scale, peeling layers, surface defects and contaminants when wire runs through at high speed. It improves wire roundness and surface finish, laying a solid foundation for subsequent processes: wire drawing, plating, welding and stranding.
Compared with conventional carbide peeling dies, PCD Peeling Die has a service life 20–80 times longer, stable dimensional performance and impact-resistant cutting edges that resist chipping. The frequency of die disassembly, adjustment and replacement is greatly reduced, making it suitable for high-speed continuous mass production lines. Its drawbacks include higher unit cost and longer processing cycle, so it is mainly used in high-end scenarios with strict requirements for wire quality.

Welding material industry (core scenario) Used for surface peeling of solid welding wire, flux-cored wire, titanium alloy welding wire, copper-aluminum wire and precious metal welding wire. It removes the oxide layer on the base material surface, ensures uniform plating and stable welding arc, and reduces pores and spatter defects. It is standard tooling for gas-shielded welding wire production, applicable to carbon steel wire, stainless steel wire, titanium wire, brass wire, etc.
Electric cables & new energy wiring harnesses Used for peeling treatment of copper rods, aluminum rods, aluminum wire and alloy conductor wire to remove oxide scale and burrs generated during continuous casting and rolling. Suitable for pre-treatment of conductors for new energy vehicle high-voltage harnesses, photovoltaic cables and enameled wires. It guarantees clean conductor surface, enhances adhesion of insulating coating and stabilizes electrical conductivity.
Special metals & precision alloy wire Applied to high-purity copper wire, aluminum wire, titanium wire, gold wire, silver wire, tungsten and molybdenum wire and other precious & refractory alloy wires. Widely used for semiconductor lead wire, sensor wire, medical alloy wire, precision spring wire, piano wire and engine valve spring wire. It ensures scratch-free surface and high dimensional precision of finished precision parts.
Steel cord, steel wire rope & prestressed steel wire industry Used for peeling high-carbon steel wire, alloy steel wire and stainless steel wire to remove oxide scale from hot-rolled wire rods. It reduces wear of downstream drawing dies and improves strength and fatigue resistance of finished steel cords, steel wire ropes and prestressed steel strands.
Other precision metal profile processing Some specifications support precision surface peeling of small-diameter copper rods and aluminum rods, and are installed on rod & tube finishing production lines. Used for pre-processing of high-precision metal raw materials in aerospace, medical equipment and instrumentation industries.
With the rapid development of new energy, high-end welding equipment, semiconductor and aerospace industries, requirements for wire surface quality and batch consistency keep rising. PCD Peeling Die solves the pain points of fast wear of traditional dies, unstable wire surface quality and frequent production shutdowns for die replacement. It raises yield rate, extends die replacement cycles and lowers the unit processing cost of wire. It represents an important application of superhard materials in the field of precision finishing of metal wire.